Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Mars 100E NTP and Reporting Issue

Two questions -

1) How or where do you setup the Mars 100E for NTP? Again, I see nothing in the GUI for this.

2) I've got a report that emails me an Event type: TCP Segment Overwrite each morning. However, in the "host" column it always states "hostname could not be resolved." This issue has been seen through out any incidents. Would this be an indication that the unit can't gain access to an external DNS source? How do I resolve this within the Mars unit itself?

~Steve

1 REPLY
Silver

Re: Mars 100E NTP and Reporting Issue

Steve,

I don't know if you figured out the NTP issue.

It is configured via the CLI. Do a ? once you have logged in and you will see the options for configuring an NTP server. There is nothing in the GUI.

To configure DNS you go to Admin-->System Setup and at the bottom of the page is the place to enter DNS servers.

Hope this helps.

Paul

121
Views
0
Helpful
1
Replies
CreatePlease to create content