01-13-2009 08:05 AM - edited 03-10-2019 04:27 AM
I'm trying to find a way to set the time in our Mars 100E unit. I'd like to set the time manually and figure out how to get it to seek out an NTP server to remain accurate. I see nothing in the GUI interface under admin or maint to set time. Any assistance would be greatly appreciated.
Solved! Go to Solution.
01-14-2009 08:01 AM
Hi Steven,
This is not an intuitive process so don't worry.
Try the following:
To set the time zone use a console connection and then enter "timezone set" command to specify the time zone in which the appliance is running.
Hope this helps to answer your question.
Best,
Paul
01-14-2009 08:01 AM
Hi Steven,
This is not an intuitive process so don't worry.
Try the following:
To set the time zone use a console connection and then enter "timezone set" command to specify the time zone in which the appliance is running.
Hope this helps to answer your question.
Best,
Paul
01-15-2009 07:27 AM
Does the 'timezone set' command allow you to set the time or simply the timezone? Obviously I haven't tried it yet.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide