In a heterogeneous, non-Cisco environment (e.g. Dell switches, Sidewinder firewall), is it possible to obtain accurate topology/visualization information? If so, how is this accomplished? Any other best-practices/gotchas for getting the most out of MARS in such environment would be helpful as well. Thank you.
We don't really have any topology information in MARS, and for the most part don't pay much attention to the topology or attack graphs/charts. Don't even use the summary page. We don't use the MARS for anything but collecting events. Maybe I don't know what I'm missing, but we get along just fine without(we even have a mostly Cisco network).
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...