I'm getting some alarms for signatures that I think are a bit too sensitive -- 3051, for example. It makes sense to me to adjust the Minhits or AlarmInterval to make the signature less sensitive, increasing the level of activity before an alarm occcurs.
However, in every signature I've seen, the AlarmInterval is blank. Is it not used? How can I adjust it if I don't know what it is now? Should I adjust something else? I'm soooo confused!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...