Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Minimum IOS version for IPS sensor v6 on CAT6500 series

What is the recommended minimum Cisco IOS Software that will support Cisco IPS Sensor Software v6 on the CAT6509

2 REPLIES
Gold

Re: Minimum IOS version for IPS sensor v6 on CAT6500 series

It depends on your Supervisor Engine, MSFC/PFC and capture method.

There's a good IDSM "software and hardware requirements" table here (but better elesewhere on CCO)

http://cisco.com/en/US/docs/security/ips/5.0/installation/guide/hwIdsm2.html

•Catalyst software release 7.5(1) or later with Supervisor Engine 1A with MSFC2

•Catalyst software release 7.5(1) or later with Supervisor Engine 2 with MSFC2 or PFC2

•Cisco IOS software release 12.2(14)SY with Supervisor Engine 2 with MSFC2

•Cisco IOS software release 12.1(19)E or later with Supervisor Engine 2 with MSFC2

•Cisco IOS software release 12.1(19)E1 or later with Supervisor Engine 1A with MSFC2

•Cisco IOS software release 12.2(14)SX1 with Supervisor Engine 720

New Member

Re: Minimum IOS version for IPS sensor v6 on CAT6500 series

7.02(3) is good match for rev 6 SSM software. I have it running this way and its been very stable.

149
Views
0
Helpful
2
Replies
CreatePlease login to create content