Monitor disk usage using snmp on the IPS 5.1 sensor

[r.stahlbrand]

Hi

I was wondering if it is possile to monitor the diskspace on the partitions of the sensor by using the built in snmpd on the IPS 5.1 sensor appliance. When i try to snmpwalk the sensor i cant see the usual net-snmp stuff.

The "cisco.ciscoMgmt.ciscoCidsMIB" entries are showing up nicely but they dont give any output concerning the disk in the sensor.

[b.hsu]

I believe there must be a CLI way to find out the disk space information on the sensor. Anyone know this command?

[mhellman]

I assume you're talking about scripting this? Probably the easiest thing to do would be to use Curl. I've attached an example. You'll need to change a couple values for it to work.

The output is different than what you'd get if you did a "df" using the service account. You'll have to decide which output you require.

[mhellman]

Here is the attachment.