I have two Cisco 6504-E's which have a IDSM-2 module in each chassis. The supervisors are configured in VSS mode. How should i configure my IDSM-2 modules for resilience?
I am planning on using Inline VLAN pairs and i was going to etherchannel the two IDSM modules but found that you cannot do this in VSS if the IDSM's are in different chassis', so how should i configure them? Do they run Active (in VSS master chassis)/Passive (in VSS standby chassis) so should they be configured the same?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...