Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

My localities are wrong in signature events

In my viewed events on the IPS module my localities are incorrect. It always lists internal addresses as OUT rather than IN. I've looking through the configuration and docs but only found the AD internal/external zone settings - which are correct anyway.

Where or how does the IPS learn what is inside and what is outside? Would it exhibit this behaviour if I've only got the security policy for traffic sent to the IPS module enabled for just the outside interface?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: My localities are wrong in signature events

In the network IPS sensor, you define the networks using event variables. Everything not defined is OUT. I would guess based on the behavior you're seeing that the module is the same.

2 REPLIES
Gold

Re: My localities are wrong in signature events

In the network IPS sensor, you define the networks using event variables. Everything not defined is OUT. I would guess based on the behavior you're seeing that the module is the same.

New Member

Re: My localities are wrong in signature events

Thank you, I thought the sensor was incorrectly seeing internal traffic as external. I've added an event variable for our internal subnets and its now showing in the event logs.

115
Views
0
Helpful
2
Replies