Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Need additional interface for IDS-4250

I need to add an additional interface to my IDS-4250 (Cisco part number IDS-4250-TX-INT). Unfortunately, these parts are now in an "end-of-sale" status as of May 31, 2005. Does anyone know what PCI NIC this part number really is? I'm sure it's just a "normal" NIC (3Com, Intel, etc.) that Cisco was using. Any help would be appreciated.

3 REPLIES
Cisco Employee

Re: Need additional interface for IDS-4250

You are looking for the wrong part number.

The part number you want is: IDS-TX-INT= (10/100/1000Base-TX for IDS 4235, 4250)

And it is still being sold by Cisco (List price $300).

It is only the base chassis IDS-4250-TX-K9 part number that has been End Of Saled in May.

The optional 10/100/1000 PCI NIC IDS-TX-INT= is still being sold for customers to upgrade their IDS-4250-TX sensors. The primary purpose for selling the additional NIC is to support InLine mode on the IDS-4250-TX sensors.

The IDS-TX-INT= can also be used in a IDS-4235 chassis for customers wanting to run InLine mode on their IDS-4235.

Because it can be used in both the IDS-4235 and IDS-4250-TX it was decided to not put 4235 or 4250 in the product number.

NOTE: IDS-4250-TX-INT is not a valid part number.

New Member

Re: Need additional interface for IDS-4250

Thank you. I obtained that part number from http://www.cisco.com/en/US/products/hw/vpndevc/ps4077/products_module_installation_guide_chapter09186a008043d7bc.html

Here's an excerpt:

You can install the following optional PCI cards in IDS-4235 and IDS-4250. The optional PCI cards provide additional sensing interfaces.

•TX card (10/100/1000TX sensing interface, part number, IDS-4250-TX-INT=)

I'll pass the part number you provided along to my vendor. Thanks again. I really appreciate the information.

Graham

New Member

Re: Need additional interface for IDS-4250

You have found an error in our documentation. This should be corrected in the next version.

Thanks!

-Rusty

142
Views
0
Helpful
3
Replies
CreatePlease to create content