Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

New internet circuit not working with IDS

We are upgrading out internet to a bonded t-1. Two new circuits have been installed. For some reason, the IDS will not allow internet traffic via the new circuits. Everything is exactly the same from a IP address/Network standpoint. The only difference is the Ethernet port speed coming out of the new router going into our switch is 100meg and the old router is 10meg? Not sure if that is the problem or not. Any help/suggestions would be appreciated.

2 REPLIES
Cisco Employee

Re: New internet circuit not working with IDS

Make sure your IPS port is in auto-negotiate mode. You might have had to explicitly config it to 10M to get that speed before.

New Member

Re: New internet circuit not working with IDS

I have had them set it to 10meg and we are going to try it again at noon today. I will post the results. Thanks.

127
Views
0
Helpful
2
Replies
CreatePlease login to create content