Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

NM-CIDS-K9 module with VRF

Hi,

Have a IDS Network module set to an unnumbered interface running through a VRF. When I try to initiate a session I get an error "gateway or host down" the loopback that the vrf is linked to is up, the status of the module is ok. I cannot ping the module address but I'm assuming it's because ping has been turned off. do I have to do anything special because it's in a vrf?? Thanks.

2 REPLIES
Silver

Re: NM-CIDS-K9 module with VRF

Could you please upload the configuration so that an exact analysis could be done.

Community Member

Re: NM-CIDS-K9 module with VRF

Hi,

I found out the module does not support virtualisation... it's right there in the manual.. when in doubt, read the book I guess is the lesson I have learned.. Thank you for the help. though...

136
Views
0
Helpful
2
Replies
CreatePlease to create content