Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

NM-CIDS-K9 on 2821

Hi,

I installed a NM-CIDS-K9 Module into my 2821 router running 12.4.8 (C2800NM-ADVSECURITYK9-M). My IDS module is running 5.0(2)S152.0. The issue I have is that the Interface IDS-Sensor 1/0 of my router is going up and down every 10 seconds. I configured ip cef and followed the Cisco Manual, but I cannot figure out why this happen. Is this a IOS bug or do I need to upgrade the IDS ?

Any help would be appreciated !

Francois

1 REPLY
Silver

Re: NM-CIDS-K9 on 2821

The issue may be due to the cabels or the interfaces that are connected to sensor may be down due to hardware problem. Check the hardware compnonet of the IDS sensor.

176
Views
0
Helpful
1
Replies
CreatePlease to create content