Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problems to update a sensor from 5.0

When i try to install the service pack to a sensor IPS 4250 XL with version 5.0 appears the following:

Eror: Cannot communicate with mainApp (getVersion). Please contact with your administrator.

And some minutes later i lost the communication with it (no pinging request).

Any suggestion?

1 REPLY

Re: Problems to update a sensor from 5.0

Are you doing it over the network? Try to connect it direct to your pc/laptop using cross-over cable.

Also, not necessary to configure gateway as both devices are connected directly without any L3 device in between.

Rgds,

AK

115
Views
0
Helpful
1
Replies