Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Procedure to Power Off the ISDM-2 Module

Hi Everyone,

I need to inform the operator the procedure he needs to make to power off the ISDM-2 Module. I want to avoid give him access to an administrator account, but I can?t see another way.

Any tip to automatizate this procedure and not requer a lot of commands by the operator ?

Thanks in Advanced

Andre Lomonaco

1 REPLY
Silver

Re: Procedure to Power Off the ISDM-2 Module

You need to use following command to poweroff the IDSM-2 module from the module-

reset [powerdown]

The reset command without any options will cause the IDSM-2 to perform an orderly reboot. If you add the powerdown option, the IDSM-2 will perform an orderly shutdown and will either power off the device or place it in a state where it can be powered off.

Regards,

Vibhor.

133
Views
5
Helpful
1
Replies
CreatePlease to create content