Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

" Configure the NME IPS to capture traffic for IPS"

Dear All,

I configured and installed NME-IPS-K9 with Cisco Router 2811 series, I am seem not clear How to configure NME IPS to capture traffice for intrusion

prevention. I have three questions:

          1. what happens or effects if conigure NME IPS with below command without access-list?

               R1(config)#interface fastEthernet 0/1

               R1(config-if)#ids-service-module monitoring inline

          2. what happens or effects if configure NME IPS with access-list?

               R1(config)#interface fastEthernet 0/1

               R1(config-if)#ids-service-module monitoring inline access-list 101 (access-list 101 permit tcp any eq www any )

          3. How to confgiure NME IPS to capture traffic from specific host?

Thanks in advance for your help

Best Regards,

Sarem Phy

H/P: 092562630

415
Views
0
Helpful
0
Replies
CreatePlease to create content