Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

"Scope: Global" not changes After click on sensor icon in ObjectSelector

"Scope: Global" not changes After click on the sensor icon in ObjectSelector. So, I cannot configure the sensing interface for individual sensor. I have installed Java Runtime Environment 1.4.1_02. My Common Services is 2.2 SP3 with IDSMC 2.0.2.

Any one know if this is proper or improper? I met this case in several VMS installed on my customer's environment. The network have one Sensor 4210 and it is in the Global group.

Thanks!

Jason

1 REPLY
New Member

Re: "Scope: Global" not changes After click on sensor icon in Ob

I think the issue is with interfaces. Try this out to recover from the issue

--Enable and disable control of physical interfaces and interface groups.

Assign physical sensing interfaces to interface groups.

193
Views
0
Helpful
1
Replies