Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Receiving the following alert thousands of time a day: Too many total in process partial IP datagrams in the system

The signature on the alert is 1205. The attacker is 0.0.0.0 and the target is 0.0.0.0. Does anyone know what is causing this? Or how I can tune this alert out? Any help would be greatly appreciated.                  

Everyone's tags (2)
1 REPLY
Bronze

Receiving the following alert thousands of time a day: Too many

You may take a packet capture and verify the IP address.

Also Modify the signature in IDM and under "Alert Frequency" change "Summay Mode" to Summarize

Regards,

Sawan Gupta

Thanks & Regards, Sawan Gupta
461
Views
0
Helpful
1
Replies
CreatePlease to create content