I have to run the "recover application-partition" on some IPS/IDS devices we have after a botched upgrade. I have successfully completed this on a Cisco 4260 Sensor and all went well.. the remaining devices are IDSM-2 cards in 6509's..
my question is if I run this command on the 6509 can anyone confirm this will not affect the 6509 switch the module is installed in?
The recover application-partition on an IDSM-2 will not affect the switch software or switch configuration.
However, if the IDSM-2 is configured for inline operation, then the traffic currently passing through the IDSM-2 will no longer pass (because the IDSM-2 configuration will be removed as a result of the recover-app).
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...