I have two ASA's in a redundant configuration. Each one has an AIM SSM-20 in it. If I make changes to the "live" SSM-20 is there a way to make it write the config over to the one in the ASA that's in standby mode?
Does the standby SSM-20 need to have it's own unique IP address or can it share the "primary" SSM's address?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...