Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Saving config on IDSM-2 module

Is there a seperate save command on an IDSM-2 module or is it saved when you 'wr me' on the switch in which it is installed?

1 REPLY
Cisco Employee

Re: Saving config on IDSM-2 module

The IDSM-2 configuration is stored and managed separately from the switch configuration.

The IOS configuration has separate running and saved configurations. Using the "wr mem" on the IOS switch causes the running configuration to be saved.

The IDSM-2 configuration, on the other hand, does NOT have separate running and saved configurations. When a configuration change is made then the single configuration is changed. You can consider it as both the running and saved configuration being modified at the same time.

245
Views
0
Helpful
1
Replies
CreatePlease to create content