11-08-2013 11:28 AM - edited 03-10-2019 06:05 AM
I have a IDSM blade for a 6500 series switch. I need to modify the administrative access-list from the CLI so I can get into it remotely and with CME
I see in the config entries like this
access-list 192.168.100.10/32
I assume this is the section for authorized hosts to access the IDSM
but I can't figure out how to add an entry?
any advice would be great
Solved! Go to Solution.
11-10-2013 11:18 PM
on the console you can add entries the following way:
in conf-mode:
service host
network-settings
access-list 10.10.10.0/24 ! or whatever you want to add
exit
exit
answer "yes" to apply changes
exit
!(ready)
Sent from Cisco Technical Support iPad App
11-10-2013 11:18 PM
on the console you can add entries the following way:
in conf-mode:
service host
network-settings
access-list 10.10.10.0/24 ! or whatever you want to add
exit
exit
answer "yes" to apply changes
exit
!(ready)
Sent from Cisco Technical Support iPad App
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: