Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sig Update Error

I'm getting the following error when

attempting to upgrade the signature file on a SSM-20:

"Cannot parse the current config for the component signature definition instance sig0"

5 REPLIES
New Member

Re: Sig Update Error

I am getting this exact same error when attempting to update signatures on our IDSM-2 modules.

This has happened on the last two signature definitions, S550 & S551, our IDSM-2 engine version is 7.0(2)E4.

Does anyone have a quick fix for this before I raise the issue in a TAC case?

Cheers

New Member

Re: Sig Update Error

I have the same engine version as you do. I have a TAC case open.

They had me reboot my module. Didn't fix it. I'll let you know if they come up with a solution for me.

New Member

Re: Sig Update Error

We are getting the same issue accross the board with our AIP-SSM cards.

Looks like restoring default sig values then manually updating works.  Bit of a pain as we have over 35 units to complete this on.....

Just hope it's not a regular thing .

New Member

Re: Sig Update Error

Saving your current config and defaulting the sigs, then restoring will work. Also I was advised to try defaulting sig 23899/0 and then trying the update. I'm going to try that tonight to see if it works.

New Member

Sig Update Error

Signature update S567 has the permanent fix for the issue. Update to S567 (or later) to correct the issue. Reset 23899.0 to its default settings prior to updating.


OR


Change signature 23899.0 to the default settings, for example:


# conf t

(config)# service signature-definition sig0

(config-sig)# default signatures 23899 0

(config-sig)# exit

(config)# exit

534
Views
0
Helpful
5
Replies