Network Module IDS ona 3845 router. The build is 6.0(5)E3. Up until last week, Cisco has been putting out signatures for the E3. The last one I've seen is the IPS-sig-S479-req-E3.pkg. I've noticed that over the last week they issued IPS-sig-S481-req-E4.pkg and IPS-sig-S481-req-E4.pkg.
Has Cisco ceased updating/supporting E3? If so, what are my options if I am forced to keep the same hardware? As I understand it, the highest build that a 3845 NM module will support is 6.0(5)E3. If this is incorrect, please let me know.
Disk usage system is using 17.7M out of 29.0M bytes of available disk space (61% usage) application-data is using 34.1M out of 174.7M bytes of available disk space (21% usage) boot is using 39.1M out of 75.9M bytes of available disk space (54% usage) application-log is using 532.0M out of 2.8G bytes of available disk space (20% usage)
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...