Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Sourcefire Firepower: NTP setup

I have run through the quick start guide and have the module up and running but can change the ntp setting from the cli while sessioned into the module.

 

Is it under expert or system modes?

 

On the old IPS I would just run setup again, so is there an option to do that?

  • Intrusion Prevention Systems/IDS
Everyone's tags (1)
2 REPLIES
Hall of Fame Super Silver

Yes, you should be able to do

Yes, you should be able to do the following:

session sfr console

setup

The setup will prompt with defaults with what's already been setup and allow you to change from those values if you like.

New Member

that did not work. I finally,

that did not work.

 

I finally, did it through firesight.

 

the documentation is a lot better.

 

quick start

 

http://www.cisco.com/c/en/us/td/docs/security/asa/quick_start/sfr/firepower-qsg.html

 

firepower

 

http://www.cisco.com/c/en/us/td/docs/security/asa/asa92/asdm72/firewall/asa-firewall-asdm/modules-sfr.pdf

 

firesight

 

http://www.cisco.com/c/dam/en/us/td/docs/security/firesight/531/PDFs/FireSIGHT-System-User-Guide-Version-5-3-1.pdf

4720
Views
0
Helpful
2
Replies