Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

start ips module

Hi,

I have shutdown the sensor to check to some latency issues,But now i want to start it ,

when i am entering ip address ,usrename , password its not allowing connect.via asdm

we are using aip-ssm20 module

  • Intrusion Prevention Systems/IDS
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

start ips module

Hi again

No - you have "shutdown-it" - it is down - you can reload it from the ASA itself - hw-module module 1 reset og similar

best regards /ti

3 REPLIES
New Member

start ips module

Hi again

No - you have "shutdown-it" - it is down - you can reload it from the ASA itself - hw-module module 1 reset og similar

best regards /ti

New Member

start ips module

Thanks

start ips module

Hello Prashant,

If that fixed your issue please mark Tiwang answer as correct

Rate all of the helpful posts!!!

Regards,

Jcarvaja

Follow me on http://laguiadelnetworking.com

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
662
Views
0
Helpful
3
Replies