Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

TLS issue with sensor in Cisco works

HI,

Can anyone provide me with a pointer to this problem.

http://i51.photobucket.com/albums/f353/bigjoe7/IDS_TLS_issue.jpg

Where is the best place to look for the connectivity problems with sensor / device 3. Events do not indicate a problem. The sensor has been setup with a trial key, but sensor 4 (partner) is working fine. Thanks.

1 REPLY
Gold

Re: TLS issue with sensor in Cisco works

I had the same problem (at least the same symptoms), drove me crazy, one third of my sensors wouldn't connect (same software and configs on them all) I finally tracked it down to a bad line in the allowed hosts ACL. I was allowing a specific host IP address, but used a netmask for a whole subnet.

122
Views
0
Helpful
1
Replies