Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Trouble Installing license on IDSM-2

Hi,

I got my license for an IDSM-2 that I am installing (used serial number of IDSM to get it). When I go to install it, whether via the CLI or through the web interface I am informed that the license in no good...

Here's the message from the CLI:

Error: setLicenseKey : The license key on the system is invalid.

Here's the output from the "show version" command:

pcsd-suth-ids# sho ver

Application Partition:

Cisco Intrusion Prevention System, Version 5.0(2)S152.0

OS Version 2.4.26-IDS-smp-bigphys

Platform: WS-SVC-IDSM2-BUN

No license present

Sensor up-time is 7 min.

Using 236765184 out of 1983660032 bytes of available memory (11% usage)

system is using 17.3M out of 29.0M bytes of available disk space (59% usage)

application-data is using 28.7M out of 166.8M bytes of available disk space (18

usage)

boot is using 40.5M out of 68.6M bytes of available disk space (62% usage)

application-log is using 530.5M out of 2.8G bytes of available disk space (20%

sage)

MainApp 2005_Mar_04_14.23 (Release) 2005-03-04T14:35:11-0600 Run

ing

AnalysisEngine 2005_Mar_29_16.33 (Release) 2005-03-29T16:45:11-0600 Run

ing

CLI 2005_Mar_04_14.23 (Release) 2005-03-04T14:35:11-0600

Upgrade History:

IDS-K9-sp-5.0-1.2- 14:00:00 UTC Thu Mar 17 2005

Maintenance Partition Version 2.1(2)

Recovery Partition Version 1.1 - 5.0(2)

Any ideas as to where to start? is there any chance that the license file could be no good? I double-checked that it was not modified after receiving it in e-mail...

Thanks,

Tim

4 REPLIES
New Member

Re: Trouble Installing license on IDSM-2

New Member

Re: Trouble Installing license on IDSM-2

This turned out to be a 'bug' where the IDSM fails to accept a license if it is installed in slot 1. I moveed the module to another slot, as per Cisco TAC, and it accepted the license...

New Member

Re: Trouble Installing license on IDSM-2

Yeah but i have a 5520 no additional slot. is there a new IOS I should load?

Cisco Employee

Re: Trouble Installing license on IDSM-2

Derek, the above post is for IDSM-2 which is on 6500 switch platform.

You would have AIP module on ASA which is irrelevant to the bug that was found.

809
Views
0
Helpful
4
Replies
CreatePlease login to create content