10-02-2007 02:07 AM - edited 03-10-2019 03:49 AM
Hi,
I installed a AIP SMM module in an Cisco ASA 5520 device.
After poweron the status and power leds on the module are ok.
When I am trying to access the module for basic configuring (by the ASA console), I get this message:
ASA5520# session 1
Opening command session with slot 1.
Card in slot 1 did not respond to session request.
Does somebody have experience with this issue?
Do I need an extra license to activate the AIP SMM module?
Thanks in advance,
Regards,
Nico
10-02-2007 11:31 PM
Hello Nico, did you try resetting the module?
hw-module module 1 reset
Have a look at this link for more information:
http://www.cisco.com/en/US/docs/security/ips/5.0/configuration/guide/cli/clissm.html#wp1034193
HTH
Regards
Farrukh
10-10-2007 07:38 AM
Module was defective and is replaced now.
Thanks for your help.
Nico
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: