Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

UNable to Access Mangement Port Of AIP SSM 10

Hi all i configured AIP SSM 10 with a management IP 172.16.x.16/21 and gateway as 172.16.x.1 and where as my management system is 172.16.x.13/21 and with the same gateway

Iam unable to reach the AIP SSM through telnet nor through ASDM, Surprisingly i am able to ping my system from the Sensor AIP SSM when i login from ASA (session 1 )

Please help me in this regard

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: UNable to Access Mangement Port Of AIP SSM 10

When you ran "setup" on the SSM to give an ip address, did you enter your management system's ip address in the access list in order to allow your management system to connect to the SSM?

And the external interface of your SSM (the one to which the 172.16.x.16 ip address is applied), is physically wired to the same network (vlan) to which your management server 172.16.x.13 is connected?

(I assume that the wiring is correct, if you can ping it from the SSM)

2 REPLIES
Cisco Employee

Re: UNable to Access Mangement Port Of AIP SSM 10

When you ran "setup" on the SSM to give an ip address, did you enter your management system's ip address in the access list in order to allow your management system to connect to the SSM?

And the external interface of your SSM (the one to which the 172.16.x.16 ip address is applied), is physically wired to the same network (vlan) to which your management server 172.16.x.13 is connected?

(I assume that the wiring is correct, if you can ping it from the SSM)

New Member

Re: UNable to Access Mangement Port Of AIP SSM 10

Hi marcabal u solved my problem its working i forget to configure access list during setup

thanks for ur reply

171
Views
0
Helpful
2
Replies