I have AIP-SSM-10 module which is plugged into cisco ASA.The issue which I am facing is when executing the command hw-module module 1 details output from cisco ASA console I see the status of IPS has gone into unresponsive.
The output is shown as below:
ciscoasa# sh module 1 details
Getting details from the Service Module, please wait...
Unable to read details from slot 1
ASA 5500 Series Security Services Module-10
Data plane Status: Not Applicable
Becoz of this I am not able to login into IPS neither I can reimage it.
if you have tried a shutdown of the module, reset and recover and a complete power down of the ASA, then you will need to have the module replaced. I have 96 AIP-SSM modules and have ran into this very often especially on the old 6.0.x software, but not so much on the 6.1.x versions.
I have tried shutdown ASA,then performed reset also,but IPS goes first to Init status then immediately goes to unresponsive state.Since it does not show me IP address I am not able to login into the IPS also.
You are able to do this as part of the image recover process is setting the management IP (which is listed as port ip in guide). This worked for me when my SSM-AIP had not manageemnt IP and was in the unresponsive state. Please look to below guide for direction and example.
The port IP Address is the IP address you need to assign to your SSM in order for it to connect to your laptop.
Since your laptop has an IP address of 10.10.10.2, then your SSM needs an IP Address within this same subnet. I would suggest using either 10.10.10.1 or 10.10.10.3.
Since both your SSM and your laptop are on the same subnet and directly connected, then a gateway is not necessary. Traffic from your SSM can go straight to your laptop without needing to be routed. So the Gateway IP can stay at 0.0.0.0.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...