10-10-2006 04:56 AM - edited 03-10-2019 03:16 AM
I am in the process of performing the upgrade on the 4210 from 4.x to 5.x. When trying to set the signature back to the IDS 4 defaults the "param src" field still shows the Sensor rather then IDS 4 Defaults. The "prop src" shows the "IDS 4 defaults". I was able to perform the same process for other signatures which seem to work for those but these few I cannot change back and the upgrade continuously fails since the are not back to the defaults.
Any Ideas?
Solved! Go to Solution.
10-10-2006 09:04 AM
These are the CLI commands for resetting 4.x signatures back to default:
reset signatures
conf t
service virtual-sensor-configuration virtualSensor
tune-micro-engines
reset-signatures
Don't forget about any custom sigs you have on your sensor. Some convert to 5.x ok, others need to be removed.
10-10-2006 09:04 AM
These are the CLI commands for resetting 4.x signatures back to default:
reset signatures
conf t
service virtual-sensor-configuration virtualSensor
tune-micro-engines
reset-signatures
Don't forget about any custom sigs you have on your sensor. Some convert to 5.x ok, others need to be removed.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: