04-03-2007 01:01 AM - last edited on 03-25-2019 05:18 PM by ciscomoderator
Hi There
I've got some questions about the ASA AIP Module:
- Is the traffic travelling through the AIP Ethernet port to the ASA, or is it an internal circuit ?
- Can you check the AIP module if it is operating ok ?
- Is there a step-by-step manual to set up basic functions of the AIP module ?
Thank you for the answers.
Remco
04-09-2007 05:44 AM
I think that traffic travels through the AIP ethernet port to the ASA. For chacking of the AIP module Cisco works can be used or you can use link https://
Following links may help you
Managing the AIP SSM and CSC SSM:
http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_1/conf_gd/ssm.htm
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface 5.1:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/cliguide/index.htm
Installing AIP-SSM:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/hwguide/hwssm.htm
Installing and Using Cisco Intrusion Prevention System Device Manager 5.1:
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids12/idmguide/index.htm
04-10-2007 05:26 AM
Thanks for that
Do i need to configure a virtual sensor too ?
Gr.
Remco
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: