Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Upgrade a sensor 5.0 -> 5.1

Is it normal when i upgrade a sensor IDS 4250XL from 5.0 to 5.1 the AnalysisEngine stops?????

1 REPLY

Re: Upgrade a sensor 5.0 -> 5.1

Hi .. please see the notes from the release

WARNING: The sensor may take up to an additional 25 minutes after final

reboot during the installation in order to complete initialization of

the analysis engine before monitoring will begin and the sensor can be

configured. DO NOT REBOOT THE SENSOR DURING THIS TIME. Doing so will

leave the sensor in an unknown state and may require that the sensor be

re-imaged.

I hope it helps .. please rate it if it does !!!

134
Views
4
Helpful
1
Replies
CreatePlease to create content