Is there any fallback to using the acls that are applied to the ASA interfaces (inbound) also as the acl identified in my class maps that will send traffic to my ips module? I understand that doing a match all would essentially do the same thing i was just curious if there were a potential downside. Basically what i would do is create seperate class maps / polices that would be tied to their repsective interfaces. Also would that work for sending traffic allowed by a VPN filter through the IPS? Thanks.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...