Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

VMS MC 2.0.2 - Sensor contain no sensing interface

We are running VMS MC 2.0.2 for all IDS. While trying to Deploy a job in VMS Management Center for IDS Sensors, we received the following error:

"Generate failed. The configuration of Sensor xxxxx does not contain any sensing interfaces. The configuration should contain at least one sensing interface so that the sensor can obtain packets for analysis."

Can't understand what caused this problem as it is our active sensor with one sensing and one mgmt interfaces.

Your help is much appreciated.

TIA

Simone.

2 REPLIES
Silver

Re: VMS MC 2.0.2 - Sensor contain no sensing interface

An interface group provides a way to group sensing interfaces into one logical virtual sensor. Only one interface group, 0, is supported. Depending on the configuration of your sensor, you may need to assign the sensing interface to interface group 0 and enable the interface.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/csids/csids10/hwguide/hwclipr.htm#wp86441

New Member

Re: VMS MC 2.0.2 - Sensor contain no sensing interface

The interface has already been assigned to Group 0, This sensor is still active and still sniffing traffic. It is VMS MC that is complaining.

Your help is appreciated.

124
Views
0
Helpful
2
Replies
CreatePlease to create content