Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

which mode is working

Hi

In my network cisco IPS is working act as an IDS mode.

have any command that without see the physical connectivity and known the mode to see the IPS working as IDS mode or IPS mode or if have no like this command then BY IDM i can get the infrmation ?

Thanks

Biplob

3 REPLIES
New Member

Re: which mode is working

no commands !

ovt Bronze
Bronze

Re: which mode is working

Yes, many commands can show this:

sensor# sh stat virtual-sensor

can give you a hint:

List of interfaces monitored by this virtual sensor = Pair1 subinterface 0

for IPS mode and:

List of interfaces monitored by this virtual sensor = FastEthernet0/1 subinterface 0

for IDS mode.

Or use:

S1# show interfaces brief

CC Interface Sensing State Link Inline Mode Pair Status

* FastEthernet0/0 Disabled Up

FastEthernet0/1 Enabled Up Unpaired N/A

FastEthernet1/0 Disabled Down Unpaired N/A

FastEthernet1/1 Disabled Down Unpaired N/A

FastEthernet1/2 Disabled Down Unpaired N/A

FastEthernet1/3 Disabled Down Unpaired N/A

for IDS mode or:

CC Interface Sensing State Link Inline Mode Pair Status

* FastEthernet0/0 Disabled Up

FastEthernet0/1 Enabled Up Paired with interface FastEthernet1/0 Up

FastEthernet1/0 Enabled Up Paired with interface FastEthernet0/1 Up

FastEthernet1/1 Disabled Down Unpaired N/A

FastEthernet1/2 Disabled Down Unpaired N/A

FastEthernet1/3 Disabled Down Unpaired N/A

for IPS mode.

Or use setup.

New Member

Re: which mode is working

thanks

228
Views
4
Helpful
3
Replies