キャンセル
次の結果を表示 
次の代わりに検索 
もしかして: 
告知
シスコ サポート コミュニティへようこそ!あなたの ご意見 をお聞かせください。
New Member

Trunk two PRI circuits on 2951 voice gateway

Running UCM 7.1.5, 2951 voice gateway with ios 15.0(1r)M13 , has a vwic3-2MFT-T1 vwic module.  Have to PRI circuits configured on the PSTN side as a single hunt group.  Cannot get the two ports to hold their "D" channels, keep bouncing, will get MULTIPLE_FRAME_ESTABLISHED on both ports, but they cycle down after about two minutes.  Configuration for the two PRI's as one (trunked?) to be done on the router or within UCM or both?                 

1 件の返信

Trunk two PRI circuits on 2951 voice gateway

Hello,

Thank you for visiting Cisco Support Community Japan.

We are sorry that this community is intended to communicate in Japanese language. For English users, Support Community English should suit better.

https://supportforums.cisco.com/community/netpro/collaboration-voice-video/ip-telephony

Please allow us for taking your time, but please post your message in the above discussion forum so that your question has more chance to get resolved soon.

Thanks and Regards,

Cisco Support Community Japan

595
閲覧回数
0
いいね!
1
返信