Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

СCME Got wrong skinny message size on socket fd 2

Hello friends!

CME set up a couple of times the customer had no problems, everything worked. Now faced with such a situation .

Cisco router 2801 with 12.4 cme 3.3, naturally ancient, decided to upgrade , rocked image with 15.1 (cme 8.1), install, configure basic setup cme. Trying to connect ip communicator - not registered , when the debug ephone reg, registration stops at what moment and all .

If enable the debug ephone detail, I see a lot of these messages

code:

Got wrong skinny message size 1836597052 on socket fd 2

Telephones CP- 6921 -C-K9 through a pair of transit networks ( including ipsec) from another office is also not connected with the fall off in the same message .

Decided to make a downgrade to version 15.0 (cme 7.1), cisco ip communicator connected immediately , phones are not connected with the same message .

Prompt, in what may be the case , as evidenced by this post , how to set up phone registration .

Cme config currently elementary :

code:

telephony-service

max-ephones 10

max-dn 20

ip source-address 192.168.1.1 port 2000

auto assign 1 to 10

auto assign 1 to 17

user-locale RU

network-locale RU

create cnf-files version-stamp Jan January 2002 00:00:00

dialplan-pattern 1 January .. extension-length 3

max-conferences 4 gain -6

moh flash :/ its / music-on-hold.au

web admin system name popov password admincme

dn-webedit

time-webedit

transfer-system full-consult

!

!

ephone-dn 1 dual-line

number 100

ephone 1

mac-address B482.FEFF.EAB3

type CIPC

button 1:1

!

!

!

ephone 2

mac-address 5006.04FA.57D5

type CIPC

button 1:2

Thank you!

480
Views
0
Helpful
0
Replies