I have an H.323 gateway that I'm trying to get caller ID working correctly on. I've got it working to where the number and name display while the phone is ringing but when the user picks up the phone only the name displays and the number is not there.
Anyone seen this before? The origional issue was with the name not showing and I got that working with..
OK. I figured the person I talked to was giving me incorrect information.
Disreguard the issue above. The problem is when the call comes in, the number shows briefly and then it's replaced with the name only. The customer wants to see two lines in the caller ID...name on top and number below.
This worked with MGCP but after there 323 migration it's stopped. Any ideas?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...