06-21-2007 02:53 PM - edited 03-14-2019 10:13 PM
I am having a problem passing audio from one 1760 to another. There is no keying or hooking involved. I need a dedicated always open 4 wire path. Any Suggestions would be helpful.
06-21-2007 03:06 PM
Hi,
are you familiar with the command "connection trunk" ? That will make the path be always open.
Hope this helps, please rate post if it does!
06-21-2007 03:17 PM
yes i am. How can I be sure that I am directing the port correctly
06-22-2007 12:30 AM
Hello,
The once you configure the correct port under dial-peer, it will be OK.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: