Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

1760 - vic2-2BRI-/TE - vic-2FXO

Router 1760 ccme 4.1

IOS c1700-adventerprisek9-mz.124-15.T1.bin

slot0 WIC-1ADSL-I-DG

slot1 empty

slot2 vic2-2BRI-/TE

slot3 vic-2FXO

Hello, I am facing the following problem:

When I plug-in the vic-2FXO card I am unable to see (and configute) voice ports 2/0 & 2/1

I will appreciate any help.

5 REPLIES
Hall of Fame Super Gold

Re: 1760 - vic2-2BRI-/TE - vic-2FXO

Hi, send show diag. Most likely you do not have dsp resource and need to add the in the form of PVDM-256-XX modules.

Hope this helps, please rate post if it does!

Cisco Employee

Re: 1760 - vic2-2BRI-/TE - vic-2FXO

Do a SH DIAG and check the type of DSP module you have installed in the router. I suspect you don't have enough DSP resources for the 4 B channels on the 2 port BRI and the 2 port FXO ports.

Paste the SH DIAG output here so we can confirm.

Re: 1760 - vic2-2BRI-/TE - vic-2FXO

Hi all.

Seems you guys replied at the same time and made more sense to me as well.

Cheers ;-)

Thot.

New Member

Re: 1760 - vic2-2BRI-/TE - vic-2FXO

Very Fast Replay!!!

Here is the show diag.

Cisco Employee

Re: 1760 - vic2-2BRI-/TE - vic-2FXO

So now a race to give you the final answer :-)

You have a PVDM-256K-4= DSP module , which will only support 4 channels, which would be the 4 B channels of the BRI card, or the VIC-2FXO, but not both at the same time.

You will need a PVDM-256K-8= at the very least for this to work.

To understand DSP and hardware requirements , check out the DSP calculator on cisco.com -

http://www.cisco.com/pcgi-bin/Support/DSP/cisco_prodsel.pl

157
Views
18
Helpful
5
Replies