Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1760 Voice gateway T1 CAS

Hi,

I am trying to configure 1760 Router (ver 12.3.14T ) with T1-CAS as an MGCP gateway.

As part of MGCP configuration i am trying to run

"ds0-group 0 timeslots 1-24 type none service mgcp " , however this command doesn't seems to be supported on this router

VG(config-controller)#ds0-group 0 timeslots 1-24 type none service mgcp

^

% Invalid input detected at '^' marker.

I tried a couple of other IOS version without any luck. Did anyone configure 1760 as MGCP GW with T1-CAS ?

Thanks

1 REPLY
Bronze

Re: 1760 Voice gateway T1 CAS

you will need to configure the MGCP service under the dial-peer command and not in the controller.

example

dial-peer voice 1 pots

destination-pattern

service MGCPAPP (some are case sensitive so do all caps)

port (T1 voice port created in the DS0-group)

the service MGCP under the controller is used when you configure a PRI-group i think.

128
Views
0
Helpful
1
Replies