Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1760V port status issue

For T1 PRI interface, I show InStatus and OutStatus as NONE when I do a show voice port summary. The port is enabled. How do I get out of NONE status and back to IDLE so it can accept/make calls

1 REPLY
Silver

Re: 1760V port status issue

could you try calling any number and see the dubugs if the port really comes out of that None state:

could you provide these debugs:

sh voice active call

sh run

sh voicedsp

95
Views
0
Helpful
1
Replies