1. I am trying to run 6.1 DMA tool (latest version) on a 4.2(3) Pub. This is older hardware, a P3 with 18.2GB hard drives that I had to keep deleting trace files just to get 4GB to install DMA. So what is happening is that I run the export and it gives a few warnings which is fine I can fix those. But then it starts the validation process and says it will run for approximately 56 minutes. But it runs for over two hours and pegs the processor at 100% and just refreshes the status screen. The DMA webpage in the background actually times out. And as far as I can tell, nothing is actually happening. While that is going, I am getting several errors in the application log under "online" saying the the maximum connections 44 is being hit. Has anyone seen this or do I just not have enough horsepower on this server.
2. If I can't get it working on that box, my next thought was to rebuild a new Publisher and do BARS to it and then run DMA on that. My question is..can I run that offline from the subs and the phones where nothing is registered or replicated or does that Pub have to be online and have all the phones registered and the other subs connected.
For question 2 - you can build a replica of your publisher and restore the BARS backup. DMA will run in this offline scenario.
If you are using DC Directory then everything will be available to DMA. If you are using AD or Netscape directory then the replica pub will need access to this directory. Could be problematic (same host name and IP Address).
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...