09-24-2007 06:01 AM - edited 03-14-2019 11:41 PM
Hi
We have a Cisco 4.2.3 CCM
When we place an international call we must wait about 20 seconds after the last digit before there is a call setup.
Is there a timer on the CCM so that we can reduce the 20 seconds until 5 seconds ?
09-24-2007 06:14 AM
Hi Rene,
Here is a good doc that explains the necessary steps;
Delay in Call Establishment: Configuring the Interdigit Timeout
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800dab26.shtml
Hope this helps!
Rob
09-24-2007 09:15 AM
Another method may be to try and more closely match your route patterns to your dial strings.
use 9.011!# instead of 9.011! and have the users enter the # key after the number is complete.
If that doesn;t work, insert a test pattern that exactly matches your dial stinrg. That should help you determinw whether the issue lies within CCM or at the carrier.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: