Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

20 seconds to make an international call

Hi

We have a Cisco 4.2.3 CCM

When we place an international call we must wait about 20 seconds after the last digit before there is a call setup.

Is there a timer on the CCM so that we can reduce the 20 seconds until 5 seconds ?

2 REPLIES
Hall of Fame Super Red

Re: 20 seconds to make an international call

Hi Rene,

Here is a good doc that explains the necessary steps;

Delay in Call Establishment: Configuring the Interdigit Timeout

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800dab26.shtml

Hope this helps!

Rob

New Member

Re: 20 seconds to make an international call

Another method may be to try and more closely match your route patterns to your dial strings.

use 9.011!# instead of 9.011! and have the users enter the # key after the number is complete.

If that doesn;t work, insert a test pattern that exactly matches your dial stinrg. That should help you determinw whether the issue lies within CCM or at the carrier.

189
Views
0
Helpful
2
Replies