Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2600 VWIC-1MFT-E1 back to back connection

Hi

Can anyone confirm weather it is possible to connect two 2600 back to back with the VWIC-1MFT-E1, wanted to look at simulating voice services over PRI connection, both routers will act as back to back H323 gateway.

Thanks

Bill

3 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Gold

Re: 2600 VWIC-1MFT-E1 back to back connection

absolutely doable, configure clock internal on one side and line on the other. isdn network side on one and user on the other.

Re: 2600 VWIC-1MFT-E1 back to back connection

To illustrate what Paolo mentioned above.

R1

controller e1 1/0

clock source internal

pri-group timeslots 1-6

framing <>

linecode <>

int s1/0:15

isdn protocol-emulate network

R2

controller e1 1/0

clock source line

pri-group timeslots 1-6

framing <>

linecode <>

int s1/0:15

isdn protocol-emulate user ### default config

Re: 2600 VWIC-1MFT-E1 back to back connection

Bill,

For 2600XMs you will need

a. Nm-hdv with pvdm12

b. nm-hdv2 with pvdm2-x (x=8,16,32,48,64)

HTH

Sankar

PS: please remember to rate posts!

4 REPLIES
Hall of Fame Super Gold

Re: 2600 VWIC-1MFT-E1 back to back connection

absolutely doable, configure clock internal on one side and line on the other. isdn network side on one and user on the other.

Re: 2600 VWIC-1MFT-E1 back to back connection

To illustrate what Paolo mentioned above.

R1

controller e1 1/0

clock source internal

pri-group timeslots 1-6

framing <>

linecode <>

int s1/0:15

isdn protocol-emulate network

R2

controller e1 1/0

clock source line

pri-group timeslots 1-6

framing <>

linecode <>

int s1/0:15

isdn protocol-emulate user ### default config

New Member

Re: 2600 VWIC-1MFT-E1 back to back connection

Thanks for the response.

I was also wanting to test call manager express with the VWIC-1MFT-E1 to setup back to back connection.

I noticed that the 2600 does not have onboard DSP capability how will the router manage DSP as the VWIC-1MFT-E1, do I also need to add an NM module with DSP.

Thanks

Bill

Re: 2600 VWIC-1MFT-E1 back to back connection

Bill,

For 2600XMs you will need

a. Nm-hdv with pvdm12

b. nm-hdv2 with pvdm2-x (x=8,16,32,48,64)

HTH

Sankar

PS: please remember to rate posts!

458
Views
0
Helpful
4
Replies