Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 HWIC 4 ESW

Hello All,

I have a Cisco 2811 running IOS adventerprisek9-mz.12.4-15.T and a

HWIC-4ESW POE installed. When I plug in a 7960 phone it does not power up....thoughts please

Thanks

6 REPLIES
Hall of Fame Super Gold

Re: 2811 HWIC 4 ESW

Do you have the POE PS ? "show env" to know.

New Member

Re: 2811 HWIC 4 ESW

Yes, I do

Hall of Fame Super Gold

Re: 2811 HWIC 4 ESW

Do you have power inline under interface? Beside that I'd to see "show diag" and "show env".

Re: 2811 HWIC 4 ESW

Hi,

Can you please paste the show diag output and cross verify if you see "ILPM-4=" part number in that output.

Also check if the power supply which you have is "AC-IP".

-> Sushil

Cisco Employee

Re: 2811 HWIC 4 ESW

If you have the ILPM module for the HWIC and a POE enabled power supply in the router - make sure you have the cable that runs from the poe supply to the motherboard.

HTH.

Re: 2811 HWIC 4 ESW

Likely power supply is not AC-IP model.

322
Views
0
Helpful
6
Replies