Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 multiple h323-providers

Hi!

I have a 2811 and two ISP with h323-voice (see scheme at attach). ISP-1 requires use interface0/0 address for voice communication. ISP-2 requires use interface0/1 address for voice communications. 2811 are registered as h323-gateway in UCM with address 192.168.44.5 How can I configure 2811 to use correct VOIP-adress to setup voice communications with each ISP? How to configure h323-gateway to use diffirent interface with multiple h323-peers?

1 REPLY

Re: 2811 multiple h323-providers

You should be able to use the bind command for each dial peer so it takes the "correct" route.

160
Views
0
Helpful
1
Replies