Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811, PVDM2-16, do I need configure 'flex' to support 16ch?

I confiugred T1 timeslot 1-16 and 'show voice dsp' displays 16 channel but nothing configured under 'voice-card 0'

as per doc, 'medium' codec complexity is default and it supports 8 channel.

Do I have 8 channels only since 'medium' complexity by default? If yes, is it mendatory configuring 'flex' to support 16 channels?

Thanks in advance,

1 REPLY
Bronze

Re: 2811, PVDM2-16, do I need configure 'flex' to support 16ch?

Nothing will show up under voice-card 0 if you are just configuring a T1. The voice-card configurations are used for conferencing, transcoding, and MTP resources.

If you have a PVDM2-16 in your router and the T1 configured for slots 1-16, you are using all available DSP resources. If you want to enable the above resources, you will need to add additional PVDM's to your router.

Thank you,

Jon

351
Views
0
Helpful
1
Replies
CreatePlease login to create content